Report

[Laser cut and engrave] Paint Stand — Project made with M1 machine for Laser cut and engrave.

[Laser cut and engrave] Paint Stand — Project made with M1 machine for Laser cut and engrave.

[Laser cut and engrave] Paint Stand — Project made with M1 machine for Laser cut and engrave.

[Laser cut and engrave] Paint Stand — Project made with M1 machine for Laser cut and engrave.

[Laser cut and engrave] Paint Stand

[Laser cut and engrave] Paint Stand

[Laser cut and engrave] Paint Stand

[Laser cut and engrave] Paint Stand

Paint Stand

ID 14181

Instruction

Files

Original files

AuthorM1 · 1/8"(3mm) Basswood Plywood

1

Add Make Profile

Same design, different machine, material, or any improvement · Earn 100 Credits

Tips for a great Make Profile →

gift

3

436

Information

      I made these out of scrap wood.  Often, I've made a project on the M1 and need to lift the material as I paint edging.  These are customizable sizing.  There's 1/2 inch spacing of notches to let you set the size to what you need.  
These are sized to be made out of 3mm stock.  The file has the top-notched and bottom-notched sizes.  and the working parts over to the side if you need to adjust notch sizing for you stock material.

Instruction

1

Step1: Load file into the machine

Arrange the cut files over your leftover scraps and cut as many as needed.

2

Step2: Use stands

The stands can be arranged in any configuration needed to support your project material. stand pieces can be chained in as many as needed.

Hope this is a useful tool for you.

Comments

Remixes

License