HomeTemplatesDecorSeasonal & Themes DecorHolidays Decor
devans1202
Report
[Laser cut and engrave] Show Off This Thanksgiving
Project made with xTool D1 machine for Thanksgiving.
Project made with xTool D1 machine for Thanksgiving.
[Laser cut and engrave] Show Off This Thanksgiving
Project made with xTool D1 machine for Thanksgiving.
[Laser cut and engrave] Show Off This Thanksgiving
[Laser cut and engrave] Show Off This Thanksgiving
[Laser cut and engrave] Show Off This Thanksgiving
[Laser cut and engrave] Show Off This Thanksgiving
[Laser cut and engrave] Show Off This Thanksgiving

Show Off This Thanksgiving

Application scenario
Laser (20min)
Machine & module
xTool D1
Material used
3mm Basswood Plywood (6pcs)
178

Information

      Rustic Napkin Ring
I made these cute napkin rings in about 20 mins, plus drying time.
Rings are 1.75 inches, offset to 1.5 inches center to create a 1.5 in area for napkin. 5.2 mm wood, two rings, glued together.
The turkey was an illustration from PIXABAY!
Cut your pieces, glue together, insert napkin and BAM! SO CUTE! And made from scraps.
I paired this with my Thankful stencil (See How-Tos)
Comments

Remixes

xTool Supplies Used in This Template

xTool D1
xTool D1
3mm Basswood Plywood (6pcs)
3mm Basswood Plywood (6pcs)