Eagle Head Relief Engrave
Instruction
Information
This is another relief project that finished up on my S1 40 Watt Laser.
Instruction
Step1: Select your Wood
Select a clean piece of 6" by 6" maple (or other hardwood). Sand the surface with progressively finer grits of sandpaper until smooth.
Step2: Load the File and Set Up for Engraving
Place the 6" by 6" maple into the laser. Adjust your focus and set the engraving area.
Make any necessary adjustments based on the power of your laser. The settings for this project were created for the S1 40 watt laser.
Step3: Finishing up!
Once engraving is complete, carefully remove the piece from your laser. Inspect the engraving for any rough edges or imperfections. Lightly sand the engraved areas if needed, taking care not to damage the design.
Choose a suitable clear wood finish to enhance the natural beauty of the maple and protect the engraving. Apply the finish evenly across the surface, following the manufacturer's instructions.
Allow the finish to dry completely, applying additional coats if desired for a richer appearance.
Enjoy your “Eagle Head Relief Engrave” relief engraving!
