Leather Bracelet with name tag

Steps to cut out the leather parts:

1. Tape with the masking tape the good side of the leather. 
2. Place the taped leather with the tape side up in the laser machine.
3. Cut out the pieces. 
4. When it is cut out, the remove tape. 
5. Clean with Isopropohal alcohol the parts from residue.

1. Change the name in the file to the name you want to engrave.
2. Then cut out and engrave the name tag.  Here we using a Two tone silver/black plastic 1.3 mm.

Steps to assemble the bracelet

1. Take the narrow white leather strap and wave it through the cutouts on right side of the bracelet.
2. The Name tag comes in the middle so wave the name tag onto the white leather strap.
3. Wave the White leather strap on the left side.
4. Pull both sides of the white leather strap so that the holes at the end are under the holes of the black leather bracelet
5. Then put some glue on the top off the white band and glue it on the back of the bracelet. Keep in mind that the hole must be see through.
6. Glue along the edge of the bottom bracelet (the one with only the hole).
7. Then put the Bracelet with white band and name tag on top of the glued bottom bracelet. And clamp it with clamps and let it dry.
8. When the glue is dry you can sew along the edges with a sewing machine.
9. Put on the snaps on both side of the bracelet. 
10. Because the name tag is a bit straight, we need to bend it a bit so that it fits nicely on your arm. You do this by placing the bracelet around a round object and heating the name tag with a hair dryer. Once it is warm, you can very gently bend the name tag so that it falls nicely round.

Your bracelet is ready