Denunciar

[Laser cut and engrave] Easter Basket — Project made with M1 machine for Laser cut and engrave.

Easter Basket

ID 7549

Instrução

Arquivos

Arquivos originais

AutorM1 · Book Board and card stock

Adicionar Perfil de Fabricação

Mesmo design, máquina, material ou qualquer melhoria diferente · Ganhe 100 Créditos

Dicas para criar um ótimo Perfil de Fabricação →

364

Informação

      I made this to fit on a narrow ledge but still look like an Easter Basket.  I cut it out of "Book Board" I found on Amazon.  I based it on a basket I made with a Cricut several years ago.

Instrução

Etapa1: Cut out the basket parts from book board or other material of choice

Cut the pieces of the basket out of sturdy material.

Etapa2: Cut grass from green cardstock

Cut the grass out of green cardstock. Alternatively you could use store bought easter grass.

Etapa3: Glue the two bottom pieces together centering the smaller on the larger. The smaller piece is there to square the sides.

Glue the two pieces of the bottom together. The larger piece is the part that actually sits on the shelf, the smaller piece is to line up the front, back and sides and give the glue something to stick to.

Etapa4: Put a line of glue all the way around the perimeter of the smaller bottom piece.

Put a line of glue all the way around the outside of the smaller piece of the bottom.

Etapa5: Set up the front and back in the glue.

Set up the front and the back in the line of glue. You may need a second set of hands.

Etapa6: Put in the sides

Put a line of glue on the sides of each of the side pieces and slide them into place. Notice that the sides are not flush with the front and the back, they are slightly indented.

Comentários