HomeLaser&Cut ProjectsKitchenTumbler
DesignFind
DesignFind
Report
[Laser cut and engrave] Goblet
Project made with M1 machine for Laser cut and engrave.

Goblet

ID 506
Instruction
Files
Original files
AuthorM1 · Heat transfer film
1
Preview
Add Make Profile
Same design, different machine, material, or any improvement · Earn 100 Credits
Tips for a great Make Profile →
gift
10
1073

Instruction

1

Step1

Import the file into the XCS software. Remove the machine baseplate and cutting mat, put the raised pillars at the bottom of the machine. Use the rotary attachment clamping the goblet and put it into the center of the machine and start focusing. Ensure that the engraving pattern is in the center of the goblet through the cross cursor and the framing.


2

Step2

Take out the carved goblet of the machine. Tear off the colored paper on the surface.


Notes

1.Make sure that the pattern is placed in the center of the engraving area of the goblet before engraving.

2.The goblet needs to be placed horizontally to prevent different carving effects caused by different heights.

3.Put the goblet in water for one minute after engraving and then tear off the colored paper to avoid damage caused by scraping the colored paper.

Comments

Remixes