Razor holder

This was rather hard to design, so I won't go into too much detail about how I made it. I made the hole as wide as the razor, then I created a backing and some small pieces that would keep it in place.

For this, I used black acrylic, but if you want, you can use a different material. However, I would stay away from wood as the bathroom is a moist environment.

Now it's time to laser. These settings are for black acrylic and an S1 40-watt machine. Also, don't forget your laser safety glasses.

For this, you need to glue the small front pieces to the holder. Then, after that, you will need to glue the back. The back is rather hard to glue and may need to be glued a couple of times.

Now for the back, I had to apply a couple of layers of glue to make sure that it would stick permanently. I also used a Command strip to hold it in place.

Now you're done with your razor holder. Good job!