Report

[Laser cut and engrave] Fan Switch — Project made with S1 machine for Laser cut and engrave.

Fan Switch

ID 9435

Instruction

Files

Original files

AuthorS1 · Black Opaque Glossy Acrylic Sheet

Add Make Profile

Same design, different machine, material, or any improvement · Earn 100 Credits

Tips for a great Make Profile →

303

Information

      Do you ever forget which cable is for the light or fan? Instead of pulling them randomly, try out this small maker that I designed for your fan. 

33/312

30creatorschallenge

fan

Instruction

Step1: Design

I created the icons in XCS using simple graphics. Next, I made the component that connects to the fan. I used a small square and two holes for this purpose. Please keep in mind that although I used acrylic, you can use any material of your choice.

Step2: Material

For this project, I used acrylic. However, you can use any material that you prefer. Since it was my first time working with acrylic, some of the engravings were not very clear. Therefore, I suggest that you do a test square before starting your project.

Step3: Laser time

Please remember that this is black acrylic and an S1 40-watt laser, so make sure to adjust your parameters for both your machine and the material. Also, always wear laser-safe glasses when laser engraving.